LinksWell LWAMP-1500-01 1500W RMS @ 1-Ohm, Class-D Mono Car Amplifier
We are a LINKSWELL authorized dealer so you get up-to-date, fully warrantied products. Shipping is free to the lower 48 states on everything you order!
What's Inside?
- • (1) D-Class Mono Subwoofer Amplifier
- • Owner's Manual
Why Choose LinksWell LWAMP-1500-01 Mono Subwoofer Amplifier?
Extreme Bass Performance Built for Enthusiasts
Unleashing a massive 1,500 Watts RMS at 1-Ohm (1000W @ 2-Ohms / 600W @ 4-Ohms), this high-efficiency Class-D monoblock pushes deep, spine-tingling bass to your subwoofers without overwhelming your electrical system. Built with precision tuning options—including variable low-pass and subsonic filters and a wide input sensitivity range—it gives you total control over every drop of power for crystal-clear, distortion-free low-end impact.
Frequently Asked Questions (FAQ)
- • Why does the amplifier keep going into protect mode?
Check the speaker impedance, wiring, and ventilation. Overheating or a shorted speaker wire can trigger protection mode.
- • Why does it get extremely hot?
Ensure the amplifier has proper airflow and that the connected subwoofer load matches the recommended impedance.
- • Why is the bass distorted at high volume?
The gain may be set too high or the input signal may be clipping. Lower the gain and retune the amplifier.
- • Why do I hear alternator whine through my subwoofer?
Inspect the amplifier ground, RCA cables, and power wire routing. Poor grounding is a common cause of engine noise.
- • Why won't the amplifier turn on?
Check the fuse, battery voltage, ground connection, and remote turn-on wire. A missing 12V remote signal will prevent startup.
- • Can I run multiple subwoofers with this amplifier?
Yes, as long as the total speaker impedance remains within the amplifier's supported operating range.
- • Why does the bass sound weak even with the gain increased?
Verify the crossover settings, subwoofer polarity, and enclosure design. Incorrect tuning can reduce low-frequency output.
- • How do I adjust the gain for the best sound quality?
Begin with the gain at its lowest setting, then slowly increase it until the bass is strong and clean without distortion.
- Maximum Power : 1500 Watts
- Number of Channels : 1
- Frequency Response : 10-200 Hz
- RMS Power Output : 1500 Watts
- Amplifier Class : D
Power Output:
- 1,500 Watts x1 @1 ohm
- 1,000 Watts x1 @ 2 ohms
- 600 Watts x1 @ 4ohms
Specifications:
- Volt Working range: 12 ~ 16
- Frequency Response: 10hz ~ 200hz
- Signal to Noise Ratio: <85db
- Input Sensitivity: 6v ~ .2v
- Variable SubSonic Filter: 10hz ~ 40hz
- Low pass Filter Variable: 40hz ~ 200hz
- Dimensions (LxWxH): 13.35″ x 5.5″ x 2″
- UPC:
- Weight: 0
- Authorized Internet Dealer
Warranty: 2 Year(s) Warranty.
This item is accompanied by a manufacturer's warranty. If it is found to be defective, it may be returned to OnlineCarstereo.com for replacement within 2 Year(s) from the original date of purchase with proper return authorization.
