SSV Works WP3-C65A-200 6.5" 120W Peak Power Handling Cage Pod Speakers for X3/X3 Max - Plug and Play to WP Overhead Systems with 2" Clamps for 2/4-Seat
We are a SSV Works authorized dealer so you get up-to-date, fully warrantied products. Shipping is free to the lower 48 states on everything you order!
What's Inside?
- • Cage Pod Speakers
- • Owner's Manual
Custom-Fit Audio Pods for Your Side-by-Side
Upgrade your Yamaha Viking, Can-Am Commander, or Maverick with molded fiberglass speaker pods and included 360° clamps. Loaded with weatherproof 6.5-inch SSV Works speakers, titanium tweeters, and durable mounting hardware, they deliver clean, powerful sound while adding a factory-inspired look to your ride.
Rugged Build. Easy Mount. Big Sound.
Built for off-road adventures, these speaker pods combine a tough textured fiberglass finish with secure stainless-steel hardware and weather-ready 6.5-inch speakers. Choose the clamp size that fits your cage and customize your Side-by-Side with optional Chroma Grilles in Orange, Red, Blue, or White.
Frequently Asked Questions (FAQ)
- • Why does the WP3-C65A-200 sound different after installation?
Speaker placement and enclosure design can significantly change the way the 6.5-inch speaker sounds. If the new speakers are installed in a different location than the originals, expect differences in bass response, vocal clarity, and overall volume.
- • What should I do if the speaker polarity was connected incorrectly?
Reverse polarity can cause the speakers to work while producing weak or unusual bass. Check the positive and negative connections on both speakers and make sure they are wired consistently with the amplifier or head unit.
- • Why does the speaker make a popping sound when the system turns on?
A turn-on pop can originate from the amplifier, source unit, or signal wiring rather than the speaker itself. Check the amplifier's remote-turn-on connection and signal connections if the noise occurs every time the system starts.
- • Can the WP3-C65A-200 be used in an open-cage UTV?
Yes, it is intended for powersports environments where the speakers are exposed to outdoor conditions. However, proper enclosure placement and secure mounting are important because an open vehicle exposes the system to substantially more vibration and environmental exposure than a car interior.
- • Why does the speaker lose clarity when mud or dirt builds up?
Accumulated dirt around the grille or cone area can interfere with normal sound dispersion. Cleaning the exterior carefully and keeping debris from building up around the speaker can help maintain consistent audio performance.
- • What happens if my amplifier is rated higher than the speaker?
A more powerful amplifier is not automatically a problem when the system is properly configured. The important factors are clean signal levels, appropriate gain settings, correct impedance, and avoiding sustained power levels beyond the speaker's capabilities.
- • Why does the sound become harsh after changing the amplifier?
A different amplifier can alter the system's gain structure and crossover behavior. Recheck the gain and filter settings rather than assuming the speaker has changed, especially if the harshness appeared immediately after the amplifier upgrade.
- • How can I prevent the speaker wires from getting damaged?
Route the wiring away from moving components, sharp edges, excessive heat, and areas where mud or debris can repeatedly pull against the cable. Securing the harness at several points can also reduce strain caused by off-road vibration.
- • Why is there less bass after installing two speakers?
Adding speakers does not necessarily increase low-frequency output. If the system's amplifier uses a high-pass filter, or if the speakers are installed in an enclosure that does not provide suitable acoustic loading, bass may remain limited.
- • How do I know whether the problem is the speaker or amplifier?
Test the WP3-C65A-200 using a known-good amplifier channel or temporarily connect a known-good speaker to the same channel. If the problem follows the speaker, inspect the speaker and wiring; if it remains with the channel, investigate the amplifier or source.
Features:
- Compatible Vehicles
- Yamaha Viking
- Can Am Commander
- Can Am Maverick
- Custom Molded Cage Mount Pods
- Includes Dual 360 degree 2″ Clamps
- 100% Fiberglass
- Black Textured Coat Finish
- Stainless Mounting Hardware Included
- SSV Works Powersports 6.5″ Speakers
- Power Handling:
- Polypropylene Cone
- Santoprene Surround
- Weatherproof Design
- 25mm Titanium Tweeter
- 4 ohms impedance
- Cutout Diameter: 5-11/16″
- Max Depth: 2-3/16″
- Custom Color Match your Side-X-Side with Swappable Chroma Grilles, Sold Separately. Available in Orange , Red, Blue and White
- Other Options Available:
- Unloaded with 1.5″ Clamps
- Loaded with 1.5″ Clamps
- Unloaded with 1.75″ Clamps
- Loaded with 1.75″ Clamps
- Unloaded with 1.85″ Clamps
- Loaded with 1.85″ Clamps
- Unloaded with 2″ Clamps
- UPC: 815172017080
- Weight: 11
- Authorized Internet Dealer
Warranty: 2 Year(s) Warranty.
This item is accompanied by a manufacturer's warranty. If it is found to be defective, it may be returned to OnlineCarstereo.com for replacement within 2 Year(s) from the original date of purchase with proper return authorization.
