SSV Works BR-2B65K 6.5" Rear Speaker Pods with Kicker KM Series 6.5" 65W RMS (195W Peak Power Handling) 4 Ohms Marine Coaxial Speakers for 2021-2025 2-Door Ford Bronco
We are a SSV Works authorized dealer so you get up-to-date, fully warrantied products. Shipping is free to the lower 48 states on everything you order!
What's Inside?
- • (2) 6.5" Speaker Enclosures
- • (2) 6.5" Kicker KM Series Speakers
- • Installation Hardware
- • Owner's Manual
Upgrade Your Bronco’s Sound with Kicker Speakers
Don’t settle for weak, factory-installed sound—elevate your Bronco’s audio experience with the SSV Works 6.5” Factory Upgrade Rear Speaker Pods featuring premium Kicker Speakers. Designed for adventure, these weatherproof, high-performance speakers deliver crisp, powerful sound, ensuring your music stays loud and clear no matter where the road takes you. Built with rugged powder-coated metal support plates for durability and plug-and-play installation, these speakers are a perfect, hassle-free upgrade—no drilling required! Experience the ultimate in-car entertainment in your 2021-2025 Bronco 2-Door and make every ride unforgettable.
Frequently Asked Questions (FAQ)
- • Why does the audio become hard to hear once the RZR starts moving?
Trail wind and engine noise can overwhelm smaller factory systems, so the BR-2B65K setup may need an appropriately powered amplifier and proper gain adjustment to maintain clear sound while riding.
- • What can cause a buzzing sound from the speakers after installation?
A buzzing noise can come from poor grounding, a loose connection, or signal wiring routed too close to power cables. Rechecking the ground and separating signal and power wiring can help isolate the source.
- • Why do the speakers suddenly cut out when the system gets loud?
An amplifier can enter protection if it is overloaded, overheated, or presented with an unsuitable speaker load. Check the amplifier's impedance requirements, ventilation, and speaker wiring before continuing to increase the volume.
- • How do I prevent the speaker enclosure from vibrating against the vehicle?
Make sure the mounting hardware is tight and that the enclosure is properly seated against its mounting surface. Off-road vibration can turn a small amount of looseness into a noticeable rattle.
- • Why does the left and right audio image sound unbalanced?
Incorrect balance settings, reversed speaker polarity, or a connection problem on one channel can make the stereo image appear to come mostly from one side. Verify channel wiring before changing the equalizer settings.
- • Can a factory Ride Command system provide enough power for an aftermarket speaker upgrade by itself?
Usually, the factory head unit is not intended to provide the power required by a higher-output aftermarket setup. RZR owners frequently report adding an amplifier because factory output is insufficient for louder trail listening.
- • What should I inspect if sound disappears after riding through water or mud?
Check the speaker connectors, amplifier connections, and exposed wiring for moisture, contamination, or a connector that has become loose. UTV audio installations require careful attention to weatherproofing even when the components are designed for off-road conditions.
- • Why does the bass seem weaker after installing additional speakers?
Adding more speakers can change the overall balance of the system and make the subwoofer seem less prominent. Adjusting the amplifier's crossover and gain can restore a better speaker-to-subwoofer balance; SSV Works specifically notes that vehicle configuration can affect perceived speaker/subwoofer balance.
- • What could make the system restart or lose audio over rough terrain?
A loose power, ground, or speaker connection can momentarily interrupt the system when the vehicle hits bumps. Secure the wiring and connectors so vibration cannot pull or flex them during operation.
- • Why should I verify the vehicle model before installing the BR-2B65K?
UTV speaker systems can depend on the exact cage, dash, and factory audio configuration. Confirming the RZR model and year before installation helps prevent mounting or wiring incompatibilities; SSV Works provides vehicle-specific compatibility information for its RZR audio products.
Features:
- Coaxial Speaker: Enhances audio experience with premium Kicker Speakers
- Durable Construction: Includes powder-coated 2mm mild steel metal support plates for stability
- High-Quality Sound: Coaxial speaker design ensures superior sound output
- Plug-and-Play Operation: Seamless integration with the Bronco's audio system
- Direct Fit Replacement: Matches vehicle specifications perfectly
- Easy Installation: No drilling required for setup
- Vehicle Compatibility: Designed for all 2021-2025 Bronco 2-Door models
Specifications:
- Factory Mounting: Yes
- Plug-&-Play: Yes
- UV Resistant: Yes
- Speaker: 6.5 inch, 195w | 4ohm
- UPC: 815172019107
- Weight: 9
- Authorized Internet Dealer
Warranty: 2 Year(s) Warranty.
This item is accompanied by a manufacturer's warranty. If it is found to be defective, it may be returned to OnlineCarstereo.com for replacement within 2 Year(s) from the original date of purchase with proper return authorization.
