SSV Works RG4-F65V 6.5" Front Speaker-Pods with SSV VSpec Series Speakers for select 2018-2024 Polaris Ranger XP1000
We are a SSV Works authorized dealer so you get up-to-date, fully warrantied products. Shipping is free to the lower 48 states on everything you order!
What's Inside?
- • 6.5" Front Kick-Pods
- • SSV Works V Spec Speakers
- • Mounting Hardware
- • Owner's Manual
Effortless Installation and Premium Sound for Your Polaris® Ranger XP1000
Upgrade your Polaris® Ranger XP1000 with the Plug-&-Play 6.5" Front-Kick Speaker-Pods from SSV Works—pioneers in side-by-side audio integration. Enjoy hassle-free installation with no soldering or cutting required, just bolt the enclosures, run the vehicle-specific wiring, and hit the trails! With custom-built enclosures that seamlessly match your vehicle's factory styling, you’ll experience premium sound while riding through sand, dust, water, and snow—ensuring top-tier performance in any off-road adventure.
Enhance Your Ride with Powerful, Weatherproof Sound and Customizable LED Grilles
Elevate your audio experience with our 6-1/2" 2-way Coaxial Car Speakers, engineered for exceptional sound with 240 watts peak power and a broad frequency range. Constructed from tough, UV-protected polypropylene and Santoprene rubber, these weatherproof speakers are built to last through any adventure. Plus, the included RGB LED grilles add a stylish and customizable flair to your ride!
Frequently Asked Questions (FAQ)
- • Why does the RG4-F65V sound too bright after installation?
An overly sharp sound can come from excessive treble, amplifier gain, or source-unit EQ settings. Start with a flatter EQ and make small adjustments rather than boosting the highs heavily.
- • Why does the audio briefly disappear when the vehicle hits a hard bump?
A connector or speaker wire may be losing contact from impact or vibration. Check the terminals and secure the cable so movement does not place stress on the connection.
- • What causes a low-frequency hum when the engine is running?
A grounding or signal-routing issue can introduce engine-related noise into the audio system. Inspect the amplifier ground and keep signal wiring separated from high-current power cables where practical.
- • Why does one speaker have less bass than the other?
Incorrect polarity can cause the two speakers to partially cancel each other's low frequencies. Verify positive and negative connections on both channels before changing the amplifier settings.
- • Why does the speaker rattle only when certain music is playing?
Particular frequencies can cause the grille, mounting hardware, cage, or nearby panels to resonate. Check the installation for loose parts while reproducing the frequency that creates the rattle.
- • Why does the system sound weaker when the RZR is loaded with passengers?
Passengers can change how sound travels through the open cabin and can partially block the speakers. Speaker direction and amplifier tuning become more important when the seating arrangement changes.
- • What should I inspect if the speaker becomes intermittent after a wet ride?
Look for moisture, dirt, corrosion, or looseness around the connectors and wiring. Dry and clean the affected connection before testing the system again.
- • Why does the audio clip even though the head unit volume is not at maximum?
The amplifier gain may be set too high for the signal coming from the source. Excessive bass or loudness processing can also cause clipping before the head unit reaches full volume.
- • Can vibration loosen the RG4-F65V mounting hardware over time?
Repeated off-road vibration can gradually loosen hardware if it is not properly secured. Inspect the mounting points periodically and address any movement as soon as it appears.
- • Why does the system stop playing after extended high-volume use?
Excessive amplifier temperature, an unsuitable speaker load, or inadequate electrical supply can trigger protection. Allow the system to cool and check the amplifier's power, ground, and load before continued use.
Features:
- Product: Plug-&-Play 6.5" Front-Kick Speaker-Pods for Polaris® Ranger XP1000
- Company: SSV Works – Pioneers in integrating audio in side-by-sides
- Plug-&-Play: No soldering, cutting, or crimping! Simple installation by bolting down enclosures, running vehicle-specific wiring, and turning the key
- Factory Fit and Finish: Custom-built enclosures that match factory styling with seamless precision
- Trail Ready: Designed to withstand harsh off-road conditions like sand, dust, water, and snow, while providing premium audio performance
Specifications:
- Product: 6-1/2" 2-way Coaxial Car Speakers
- Power Handling: Peak: 240 watts per pair / 160 watts each, RMS: 120 watts per pair / 60 watts each
- Cone Material: Injection Molded Polypropylene with UV Protection
- Speaker Surround: Santoprene Rubber
- Dome Tweeters: PEI (Polyetherimide)
- Weatherproof: Dual-lock gasket
- Impedance: 4 ohm
- Frequency Response: 35 - 21,000 Hz
- Sensitivity: 90 dB
- Speaker Grilles: Included
- Grille Options: Available in RGB LED grilles
- UPC: 815172019343
- Weight: 10
- Authorized Internet Dealer
Warranty: 2 Year(s) Warranty.
This item is accompanied by a manufacturer's warranty. If it is found to be defective, it may be returned to OnlineCarstereo.com for replacement within 2 Year(s) from the original date of purchase with proper return authorization.
